Content right column
TransView Test View 01
TransView is a software for visualization and analysis of recorded analog and binary signals, often transients in the network, which were recorded with transient recorders (relay-internal recording, CMC 256/256plus/CMC 356 with ELT-1 EnerLyzer, disturbance recorder). It processes the recorded data graphically and calculates further quantities of the energy system out of the measurement data, like impedances, power vectors, rms values, etc..
The quantities can be represented as primary or secondary values in different views:
- Time signals
- Vector diagrams
- Locus diagrams
- Harmonics
- Value tables
For the analysis of a transient recording, amplitude and time measurements can be performed using two cursors. The voltage and current values on the cursor positions are displayed in the vector diagram or the value table.
The zoom function allows the representation of the values in every view with optimal scale.
TransView allows for simultaneous analysis of multiple recordings, e.g. of the two ends of a line.
TransView Comtrade
Time signals
Here analog and binary signals are represented as a function over time. Analog quantities can be displayed as instantaneous or rms values.
Vector diagrams
This view visualizes measured and calculated quantities (e.g. symmetrical components) as complex vectors at defined points in time.
Locus diagrams
This view visualizes complex quantities as locus diagrams. Impedance locus diagrams can be represented together with tripping zones of distance relays. Zone settings can be imported using the XRIO format.
Harmonics
The Harmonics view shows the rms values of harmonics of selected measured quantities as bar graphs. The amplitude values are given in absolute values and as a percentage of the fundamental. The harmonics are determined using a full-cycle DFT (Discrete Fourier Transformation).
Value table
The Table view shows the values of several signals at the cursor positions. The signals are arranged in rows, where the individual columns contain the respective values.
Fault Locator
This is an independent and autonomous function, which allows the precise location of faults even on mixed line sections by using the line data entered.
TransView supports data in COMTRADE format (IEEE Standard Common Format for Transient Data Exchange for Power Systems).
Download a demonstration of TransView
- Trans View Demo CD (2.24 MB)
- , Download the file to your local disk and extract it. Start Launch.exe to run the Demo
Alternatively you can order your TransView Demo CD-ROM free of charge by contacting the nearest you!